Laserfiche WebLink
SAMSON OCEANFRONT PARK <br />CITY OF SUNNY ISLES <br />TECHNICAL SPECIFICATIONS <br />SANITARY WASTE PIPING SPECIALTIES 15155-3 <br /> <br />1. Description: Manufactured assembly made of 6.0-lb/sq. ft., 0.0938-inch-thick, lead flashing collar <br />and skirt extending at least 8 inches <br />a. Open-Top Vent Cap: Without cap. <br /> from pipe, with galvanized-steel boot reinforcement and <br />counterflashing fitting. <br />b. Low-Silhouette Vent Cap: With vandal-proof vent cap. <br />c. Extended Vent Cap: With field-installed, vandal-proof vent cap. <br />2.05 <br />A. Open Drains: <br />MISCELLANEOUS SANITARY DRAINAGE PIPING SPECIALTIES: <br />1. Description: Shop or field fabricate from ASTM A 74, Service class, hub-and-spigot, cast-iron, <br />soil-pipe fittings. Include P-trap, hub-and-spigot riser section; and where required, increaser fitting <br />joined with ASTM C 564, rubber gaskets. <br />B. Deep-Seal Traps: <br />1. Description: Cast-iron or bronze casting, with inlet and outlet matching connected piping and <br />cleanout trap-seal primer valve connection. <br />2. Size: Same as connected waste piping. <br />a. NPS 2: 4-inch- <br />b. <br />minimum water seal. <br />NPS 2-1/2 and Larger: 5-inch- <br />C. Floor-Drain, Trap-Seal Primer Fittings: <br />minimum water seal. <br />1. Description: Cast iron, with threaded inlet and threaded or spigot outlet, and trap-seal primer valve <br />connection. <br />2. Size: Same as floor drain outlet with NPS 1/2 <br />D. Air-Gap Fittings: <br /> side inlet. <br />1. Standard: ASME A112.1.2, for fitting designed to ensure fixed, positive air gap between installed <br />inlet and outlet piping. <br />2. Body: Bronze or cast iron. <br />3. Inlet: Opening in top of body. <br />4. Outlet: Larger than inlet. <br />5. Size: Same as connected waste piping and with inlet large enough for associated indirect waste <br />piping. <br />E. Sleeve Flashing Device: <br />1. Description: Manufactured, cast-iron fitting, with clamping device, that forms sleeve for pipe floor <br />penetrations of floor membrane. Include galvanized-steel pipe extension in top of fitting that will <br />extend 1 inch <br />2. Size: As required for close fit to riser or stack piping. <br /> above finished floor and galvanized-steel pipe extension in bottom of fitting that <br />will extend through floor slab. <br />F. Stack Flashing Fittings: <br />1. Description: Counterflashing-type, cast-iron fitting, with bottom recess for terminating roof <br />membrane, and with threaded or hub top for extending vent pipe. <br />2. Size: Same as connected stack vent or vent stack.