Section 01570- Traffic Control - Laserfiche WebLink

Home Browse Search

01570 - 3/5 F. Regardless of Traffic Control Plan utilized, it shall be the CONTRACTOR's responsibility to maintain the work zone in a safe condition. G. No additional compensation shall be made for compliance with these requirements. 1.50 ACCESS FOR POLICE, FIRE AND POSTAL SERVICE A. The CONTRACTOR shall be responsible to notify the fire department and police department before closing any street or portion thereof. No closing shall be made without the OWNER'S acceptance. The CONTRACTOR shall be responsible to notify said departments when the streets are again passable for emergency vehicles. Do not block off emergency vehicle access to consecutive arterial crossings or dead- end streets, in excess of 300 linear feet, without special written permission from the fire department. The CONTRACTOR shall conduct operations with the least interference to the fire equipment access and at no time prevent such access. B. The CONTRACTOR shall provide an emergency telephone number or numbers with the police department so that contact may be made easily at all times in case of barricade and flare trouble or other emergencies. C. The CONTRACTOR shall be responsible to maintain postal service facilities in accordance with the requirements of the U.S. Postal Service. The CONTRACTOR shall move mailboxes to temporary locations designated by the U. S. Postal Service and at the completion of the Work in each area, replace them in their original location and in a condition satisfactory to the U. S. Postal Service. PART 2 - PRODUCTS 2.01 GENERAL: Coordinate with the Drawings to verify which of the following products is used in the work. 2.02 HIGHWAY SIGNING: Erecting aluminum or steel roadway signs with supporting posts, at the locations shown on the plans. The roadway signs and material shall conform to the requirements on DOT Standard Specifications: Section 700, Articles 700-1 through 700-7. 2.03 REFLECTIVE PAVEMENT MARKERS: Installing reflectorized pavement markers and removing pavement markers within the project limits as designed in the plans. The reflectorized pavement markers and materials shall conform to the requirements of DOT Standard Specifications: Section 706, Articles 706-1 through 706-2. 2.04 PAINTING TRAFFIC STRIPES: Painting reflectorized traffic stripes, including edge stripes and traffic guide. The painting and materials shall conform to the requirements of DOT Standard Specifications: Section 710, Article 710-1 through 710-2. 2.05 THERMOPLASTIC TRAFFIC STRIPES AND MARKINGS: Placing and materials shall conform to the requirements of DOT Standard Specifications: Section 711, Articles 711-1 through 711-2.