Reso 2007-1103 - Laserfiche WebLink

Home Browse Search

D I lu r' I 1! I I�IIf the Quality Control split sample for gradation, asphalt binder content and volumetrics in accordance with 334 - 5.1.1. Complete all Quality Control testing within one working day from the time the samples were obtained. 334 -5.3.2 Roadway Sampling and Testing Requirements: Obtain five 6 inch [150 mm] diameter roadway cores within 24 hours of placement at random locations as directed by the Engineer within each sublot. Test these Quality Control samples for density in accordance with 334 - 5.1.1. The Gmm used for the density evaluation will be based on the Quality Control test result for the corresponding sublot. On coarse mixes when the average density for an Initial Production sublot is less than 93.00 percent of Gmm, or an individual core density is less than 91.00 percent of Gmm, cut five 6 inch [150 mm] diameter roadway cores (at locations determined by the Engineer) and have them evaluated for permeability in accordance with FM 5 -565 by a laboratory as approved by the Engineer. If approved by the Engineer, the original cores cut for density testing purposes may be used to evaluate permeability. 334 -5.3.3 Verification of Initial Production LOT: For Verification purposes the Engineer will test a minimum of one split sample as described in 334 -5.1.1 from the Initial Production LOT at the completion of the LOT. Results of the testing and analysis for the LOT will be made available to the Contractor within one working day from when the LOT is completed. The Verification test results will be compared with the corresponding Quality Control test results based on the between - laboratory precision values shown in Table 334 -5. If all of the specified mix characteristics compare favorably, then the LOT will be accepted, with payment based on the Quality Control results for the LOT. If any of the results do not compare favorably, then the split Resolution samples from the LOT will be sent to the Resolution laboratory for testing, as described in 334 -5.6. 334 -5.3.4 Acceptance of Initial Production LOT: The Initial Production LOT shall be considered a single LOT and will receive a Composite Pay Factor as determined in 334 -8, based on results of the verified Quality Control tests, or as determined by the Resolution System. 334 -5.4 Quality Control Sampling and Testing: Obtain all samples randomly as directed by the Engineer. Should the Engineer determine that the Quality Control requirements are not being met or that unsatisfactory results are being obtained, or should any instances of falsification of test data occur, approval of the Contractor's Quality Control Plan will be suspended and production will be stopped. 334 -5.4.1 Lost or Missing Verification /Resolution Samples: In the event that any of the Verification and /or Resolution samples that are in the custody of the Contractor are lost, damaged, destroyed, or are otherwise unavailable for testing, the minimum possible pay factor for each quality characteristic as described in 334 -8.2 will be applied to the entire LOT in question, unless called for otherwise by the Engineer. Specifically, if the LOT in question has more than two sublots, the pay factor for each quality characteristic will be 0.55. If the LOT has two or less sublots, the pay factor for each quality characteristic will be 0.80. In either event, the material in question will also be evaluated in accordance with 334 - 5.9.5. If any of the Verification and /or Resolution samples that are in the custody of the Department are lost, damaged, destroyed or are otherwise unavailable for March 2007 01000 -61 03- 4122.D `-'