Reso 2009-1475 - Laserfiche WebLink

Home Browse Search

Air Handler Run Inspection (AHU-130) Description • Check the general condition of the fan. • Verify smooth fan operation. • Check and record supply and control air pressure, if applicable. • Verify the operation of the control system. • Log the operating conditions after the system has stabilized. • Review operating procedures with operating personnel. • Provide a written report of completed work, operating log, and indicate uncorrected deficiencies detected. Pump Annual Inspection (PMP-110) • Record and report abnormal conditions, measurements taken, etc. • Review customer logs with the customer for operational problems and trends. • Check motor shaft and pump shaft for alignment, if applicable. • Inspect the coupling for wear. • Verify that the shaft guard is in place and tight, if applicable. • Verify water flow through the pump. • Check for leaks on the mechanical pump seals, if applicable. • Verify proper drip rate on the pump seal packing, if applicable. • Verify smooth operation of the pump. • Lubricate the motor bearings as necessary. • Lubricate the pump bearings as necessary. • Clean the starter and cabinet. • Inspect wiring and connections for tightness and signs of overheating and discoloration. • Meg the motor. • Verify tight connections on the motor terminals. • Check the condition of the contacts for wear and pitting, if applicable. • Check the contactors for free and smooth operation. • Verify proper volts and amps. Pump Run Inspections (PMP-111) • Verify smooth operation of the pump. • Check for leaks on the mechanical pump seals, if applicable. • Verify proper drip rate on the pump seal packing, if applicable. • Provide a written report of completed work, operating log, and indicate any uncorrected deficiencies detected. ©2009 Trane All rights reserved Page 7 of 11 Select Service Agreement