Specifications - Laserfiche WebLink

Home Browse Search

rnot be employed. Chutes shall be metal or metal -lined and each section shall have approximately the same slope. The slope shall not be less than 25 nor more than 45 degrees from the horizontal and shall be such as to prevent the segregation of the ingredients. The discharge end of the chute shall be provided with a baffle plate or spout to prevent segregation. If the discharge end of the chute is more than 5 feet above the surface of the concrete in the forms, a spout shall be used, and the lower end maintained as near the surface of deposit as practicable. When the operation is intermittent, the chute shall discharge into a hopper. Chutes shall be thoroughly cleaned before and after each run, and the debris and any water shall be discharged outside the forms. Concrete shall not be allowed to flow horizontally over distances exceeding 5 feet. H. In thin sections of considerable height, concrete shall be placed using suitable hoppers, spouts with restricted outlets, or otherwise, as required or approved. Concrete during and immediately after depositing shall be thoroughly compacted by means of suitable tools. Internal type mechanical vibrators shall be employed to produce required quality of finish. Vibration shall be done by experienced operators under close supervision and shall be carried on long enough to produce homogeneity and optimum consolidation without permitting segregation of the solid constituents of "pumping" or migration of air. All vibrators shall be supplemented by proper wooden spade puddling adjacent to forms to removed included bubbles and honeycomb. This is essential for the top lifts of walls. All vibrators shall travel at least 10,000 rpm and be of adequate capacity. At least one vibrator shall be used for every 10 cubic yards of concrete placed. In addition, one spare vibrator in operating condition shall be on the site. J. Concrete slabs on the ground shall be well- tamped into place and foundation material shall be well- tamped, and rolled until thoroughly compacted prior to placing concrete. K. Concrete shall be deposited continuously in layers of such thickness that no concrete will be deposited on concrete which has hardened sufficiently to cause the formation of seams and planes of weakness within the section. If a section cannot be placed continuously, construction joints may be located at points as provided for in the Drawings or approved by the Engineer. 3.08 CURING AND PROTECTION A. Protect all concrete work against injury from the elements and defacements of any nature during construction operations. Special 07/03 03300 -12 03- 3148.A