Laserfiche WebLink
<br />Copyright 2003 AlA <br /> <br />MASTERSPEC Short Form <br /> <br />08/03 (R 05/06) <br /> <br />3.7 <br />A. <br />B. <br />C. <br />D. <br />E. <br /> <br />F. Align webs of bottom chords and load-bearing studs or continuously reinforce track to transfer <br />loads to structure. Anchor trusses securely at all bearing points. <br /> <br />G. Install continuous bridging and permanently brace trusses as indicated[ on Shop Drawings and <br />designed according to LGSEA's Technical Note 551e, "Design Guide for Permanent <br />Bracing of Cold-Formed Steel Trusses. "] [.] <br /> <br />FIELD QUALITY CONTROL <br /> <br />Testing: Owner will engage a qualified independent testing and inspecting agency to perform <br />field tests and inspections and prepare test reports. <br /> <br />Field and shop welds will be subject to testing and inspecting. <br /> <br />Testing agency will report test results promptly and in writing to Contractor and Architect. <br /> <br />Remove and replace work where test results indicate that it does not comply with specified <br />requirements. <br /> <br />Additional testing and inspecting, at Contractor's expense, will be performed to determine <br />compliance of replaced or additional work with specified requirements. <br /> <br />3.8 REPAIRS AND PROTECTION <br /> <br />A. Galvanizing Repairs: Prepare and repair damaged galvanized coatings on fabricated and <br />installed cold-formed metal framing with galvanized repair paint according to ASTM A 780 and <br />manufacturer's written instructions. <br /> <br />B. Provide ftnal protection and maintain conditions, in a manner acceptable to manufacturer and <br />Installer, that ensure that cold-formed metal framing is without damage or deterioration at time <br />of Substantial Completion. <br /> <br />END OF SECTION 05400 <br /> <br />COLD-FORMED METAL FRAMING <br /> <br />05400 - 10 <br />