Laserfiche WebLink
<br />( [}={] C!dJ [g) ~ ~ lL) <br /> <br />INSTALLATION INSTRUCTIONS <br /> <br />INCANDESCENT <br />1. Be sure power is turned off. <br /> <br />2. Loosen knuckle bolt on fixture. <br /> <br />3. Install fixture to j-box cover using thread sealing <br />compound on knuckle threads to insure watertight- <br />ness. (Masonry or earth only) <br /> <br />4. Install j-box gasket on box. <br /> <br />5. Make electrical connections. <br /> <br />6. Install j-box cover and fixture to j-box. Tighten screws <br />evenly. <br /> <br />7. Aim fixture and re-tighten knuckle bolt. <br /> <br />8. Install lamp (by others) in socket. <br />Note: <br />Use only correct type and rated Voltage lamp. <br /> <br />ACCENT LIGHTS <br /> <br />Installation should be performed by a qualified <br />electrician in accordance with the National Electrical Code <br />and relevant local codes. <br /> <br />HID & LV <br />1. Be sure power is turned off. <br /> <br />2. Remove splice box cover. <br /> <br />3. Install combo box flush with finish grade and use <br />thread sealing compound when connecting supply <br />conduit. <br /> <br />4. Install fixture to splice box cover using thread sealing <br />compound to insure water tightness. <br /> <br />5. Install splice box gasket. <br /> <br />6. Make line and load electrical connections as required. <br /> <br />7. Install splice box cover and tighten screws as shown. <br /> <br />8. Loosen knuckle bolt and aim fixture. <br /> <br />9. Re-tighten knuckle bolt. <br /> <br />10. Install lamp (by others) in socket. <br />Note: <br />Use only correct type and rated Voltage lamp. <br /> <br />INSTALLATION DIAGRAM <br /> <br />INCANDESCENT <br /> <br /> <br />HID & LV <br /> <br /> <br />r 00 NOT OPEN <br /> <br />THIS COMPARTMENT IS <br />FACTORY SEALED AND <br />SHOULD NOT BE OPENED <br />UNLESS CONSULTING <br />FACTORY. <br /> <br /> LViHID MODELS <br />TIGHTEN- c~ f 'iJ @ <br />SPLICE BOX r\,j ! @ @ <br />SCREWS USING <br />A CRISS-CROSS !;., i <br />~'11 @ @ <br />PATTERN TO 50 <br />INCH POUNDS ~\i @ ". <br />(MINIMUM). ~ @ @ <br /> <br />@2006Hydre! <br />Rev. 07/24/06 <br />INS-ACCENT-BORDER <br /> <br />NOTE HYOREl RESERVES THE RIGHT TO MOOIFY SPECIFICATION WITHOUT <br />NOTICE_ Any dimension on this sheet is to be assumed as a reference <br />dimension: "Used for information purposes only. It does not govem <br />manufacturing or inspection requirements." (ANSI Y14.5-19731 <br /> <br />1288J BrodleyAve <br />Sylma r. CA 91342 <br />Phone: 818-362-9465 <br />Fax:818-362-6548 <br />www.hydrel.com <br />