Section 00800 - Supplementary General Conditions

Home Browse Search

00800 - 3/13 B. In case the CONTRACTOR falls behind schedule or where the nature of the Work requires special attention, the CONTRACTOR may be permitted to work additional shifts or to work beyond normal working hours, provided the CONTRACTOR has requested an approval for change of its Work schedule, in writing, from the ENGINEER. In any event, the cost for working additional shifts or beyond normal working hours, unless such Work is required by a change order action or in emergency, shall be borne solely by the CONTRACTOR without any additional cost to the OWNER, including the cost of Resident Project Representative's services. If authorized, the CONTRACTOR shall provide written notice to residences that may be impacted by the work. D. None but skilled foremen and workmen shall be employed on work requiring special qualifications. Except as otherwise required by law, convicted felons who have not completed their sentences or other workers from county, state or federal prisons who are on work release programs shall not be employed for work on this project. SGC-6.5 SUBCONTRACT LIMITATIONS A. In addition to the provisions of Paragraph 6.5 of the General Conditions, the CONTRACTOR shall perform not less than twenty (20) percent of the Work with its own forces (i.e., without subcontracting). The twenty (20) percent requirement shall be understood to refer to the Work, the value of which totals not less than twenty (20) percent of the Contract Price. B. The apparent low bidder, and such bidders as the OWNER may request in writing, shall submit to the OWNER a list of all subcontractors and other persons and organizations (including those who are to furnish the principal items of materials and equipment) proposed for any portion of this Project. When this list is approved, no deviations shall be allowed from that list without the written consent of the ENGINEER. ARTICLE 6 - CONTRACTORS RESPONSIBILITIES Add the following subarticles to the General Conditions: SGC-6.11 SHOP DRAWINGS AND SAMPLES Add the following paragraphs to Article 6.11 of the General Conditions: A. CONTRACTOR shall submit Shop Drawings as required by the Technical Specifications. The purpose of the Shop Drawings is to show the suitability, efficiency, technique of manufacture, installation requirements, details of the item and evidence of its compliance or noncompliance with the Contract Documents. B. Within thirty (30) calendar days after the Project Initiation Date specified in the Notice to Proceed, CONTRACTOR shall submit to ENGINEER a complete list of preliminary data on items for which Shop Drawings are to be submitted and shall identify the critical items. Approval of this list by ENGINEER shall in no way relieve CONTRACTOR from submitting complete Shop Drawings and providing materials, equipment, etc., fully in