Laserfiche WebLink
<br />01300 - 2/9 <br />3. Refer to ARTICLE 1.03 of this Part for detailed lists of documents and specific <br />requirements. <br />B. Quality Requirements: <br />1. Submittals such as shop drawings and product data shall be of the quality for <br />legibility and reproduction purposes. Every line, character, and letter shall be <br />clearly legible. Drawings such as reproducibles shall be useable for further <br />reproduction to yield legible hard copy. <br />2. Documents submitted to the City that do not conform to these requirements <br />shall be subject to rejection by the City, and upon request by City, Contractor <br />shall resubmit conforming documents. If conforming Submittals cannot be <br />obtained, such documents shall be retraced, redrawn, or photographically <br />restored as may be necessary to meet such requirements. Contractor's (or his <br />Subcontractor's) failure to initially satisfy the legibility quality requirements will <br />not relieve Contractor (or his Subcontractors) from meeting the required <br />schedule for Submittal of shop drawings and product data. <br />C. Language and Dimensions: <br />1. All words and dimensional units shall be in the English language. <br />2. Metric dimensional unit equivalents may be stated in addition to the English <br />units. <br />D. Submittal Completeness: <br />1. Submittals shall be complete with respect to dimensions, design criteria, <br />materials of construction, and other information specified to enable the City to <br />review the information effectively. <br />2. Where standard drawings are furnished which cover a number of variations of <br />the general class of equipment, each such drawing shall be individually <br />annotated to describe exactly which parts of the drawing apply to the <br />equipment being furnished. Use hatch marks to indicate variations that do not <br />apply to the Submittal. The use of "highlighting markers" is not an acceptable <br />means of annotating Submittals. Such annotation shall also include proper <br />identification of the Submittal permanently attached to the drawing. <br />3. Reproduction or copies of Contract Drawings or portions thereof will not be <br />accepted as complete fabrication or erection drawings. The Contractor may <br />use a reproduction of the City- prepared Contract Drawings for erection <br />drawings such as to indicate information on erection or to identify detail <br />drawing references. Where the drawings are revised to show this additional <br />Contractor information, the City's title block shall be replaced with a <br />Contractor's title block and the City's professional seal shall be removed from <br />the drawing. The Contractor shall revise these erection drawings for <br />subsequent City revisions to the Contract Drawings. <br />1.03 COMPLIANCE SUBMITTALS: <br />A. Items shall include, but not be limited to, the following: <br />1. Manufacturer's specifications for materials, pipe and fittings to be used. <br />2. Catalogs, or parts thereof, of manufactured equipment. <br />3. Shop fabrication and erection drawings (Valve Vaults). <br />4. Horizontal Directional Drilling route, plan and procedures.