Reso 2007-1103 - Laserfiche WebLink

Home Browse Search

fl � 711 1 test, the Engineer will collect the remaining Verification split samples for testing. Verification Test results will be used for material acceptance purposes for the eight LOTS in question. 160 -7.4.4 Density: When a Verification or Independent Verification density test does not meet 160 -7.2.3 (Acceptance Criteria), retest the LOT at a site within a 5 feet [1.5 meter] radius of the Verification test location and observe the following: 1. If the Quality Control retest meets the Acceptance Criteria and compares favorably with the Verification or Independent Verification test, the Engineer will accept the four LOTs in question. 2. If the Quality Control retest does not meet the Acceptance Criteria and compares favorably with the Verification or Independent Verification test, rework and retest the material in that LOT. The Engineer will re- verify the four LOTs in question. 3. If the Quality Control retest and the Verification or Independent Verification test do not compare favorably, complete a new equipment- comparison analysis as defined in 120-10.1.2. Once acceptable comparison is achieved, retest the four LOTs. The Engineer will perform new verification testing. Acceptance testing will not begin on a new LOTs until the Contractor has a gauge that meets the comparison requirements. 163 BLANKET MATERIAL. (REV 9 -7 -05) (FA 1- 10 -06) (7 -06) SECTION 163 (Pages 190 and 19 1) is deleted. 200 ROCK BASE. (REV 8 -2 -05) (FA 8 -3 -05) (8 -05) ARTICLE 200 -6 (Pages 194-195) is deleted and the following substituted: 200 -6 Compacting and Finishing Base. 200 -6.1 General: A LOT is defined as a single lift of finished base not to exceed 500 feet [150 m]. Shoulders compacted separately shall be considered separate LOTS. Isolated compaction operations will be considered as separate LOTS. For multiple phase construction, a LOT shall not extend beyond the limits of the phase. 200 -6.1.1 Single Course Base: After spreading, scarify the entire surface, then shape the base to produce the required grade and cross - section, free of scabs and laminations, after compaction. 200 -6.1.2 Multiple Course Base: Clean the first course of foreign material, then blade and bring it to a surface cross - section approximately parallel to the finished base. Before spreading any material for the upper courses, allow the Engineer to make density tests for the lower courses to determine that the required compaction has been obtained. After spreading the material for the top course, scarify finish and shape its surface to produce the required grade and cross - section, free of scabs and laminations, after compaction. March 20117 01000 -40 03- 4122.D " �;