Laserfiche WebLink
0 <br />L <br />r <br />Efl <br />C <br />I <br />C <br />I <br />111� <br />r <br />u <br />0 <br />H11 <br />C <br />Ensure the test container is suitable for testing the following steel surfaces: <br />horizontal (up /down configuration), vertical, flat, curved, smooth, pitted, and rough. <br />Ensure the kit uses a test container, with resulting ion extract solution, as <br />the titration container. <br />Ensure the Ion concentrations are directly measured in micrograms per <br />square centimeter without using either conversion charts or tables. <br />560 -2.5 Abrasives: Use abrasive materials that meet the requirements of <br />SSPC -AB 1 , Mineral and Slag Abrasives, SSPC -AB 2, Cleanliness of Recycled Ferrous <br />Metallic Abrasives, or SSPC -AB 3, Newly Manufactured or Re- Manufactured Steel Abrasive <br />and do not introduce any contamination that interferes with the coating application and <br />performance. <br />Provide certification to the Engineer that the abrasives used do not contain <br />any chlorides and other salts. <br />Ensure recycled abrasive meets all requirements of this Specification each <br />time it is placed in the blast pot. <br />560 -2.6 Rust Preventative Compound: Use a rust preventative compound that <br />meets the requirements of Federal Standard TP 664. <br />560 -3 Equipment. <br />560 -3.1 Compressed Air: Use a compressed air system capable of delivering clean, <br />dry, continuous nozzle pressure to achieve the required surface cleanliness and profile or <br />spray pattern. The system must comply with the instructions and recommendations of the <br />manufacturer of the abrasive blasting system or coating application system. <br />560 -3.2 Abrasive Blasting System: Design the blasting system to produce the <br />specified cleanliness and profile. <br />560 -3.3 Coating Application System: Use the coating application equipment <br />approved by and in accordance with the Coating Manufacturer's technical data <br />requirements. <br />560 -4 Environmental, Health and Safety Requirements. <br />Isolate the work areas with containment devices canvasses, tarpaulins or screens, <br />during all cleaning and coating operations. Dispose of all debris and waste products <br />generated in accordance with all Federal, State and Local regulations. Requirements for <br />lead abatement are covered in 560 -16. <br />560 -5 Quality Assurance. <br />Develop a QC plan in accordance with Specification 105. Ensure that all inspection <br />equipment is maintained, calibrated and in good working condition. Furnish and erect <br />scaffolding to the satisfaction of the Engineer to facilitate safe inspection of all surface <br />preparation and coating application. Ensure that all activities are observed and approved by <br />a coatings inspector. <br />560 -6 Personnel Qualifications. <br />Provide documentation 'to the Engineer that all personnel performing surface <br />preparation or coating application are certified by the American Institute of Steel <br />Construction (AISC) Sophisticated Paint Endorsement or the Society for Protective <br />Coatings (formerly Steel Structures Painting Council) (SSPC) to the requirements of SSPC <br />p March 2007 01000 -129 03- 4122.D <br />