Laserfiche WebLink
<br />Copyright 2002 AIA <br /> <br />MASTERSPEC Full Length <br /> <br />11/02 (R 05/06) <br /> <br />O. Compatibility Test Reports: Prepare reports written by a qualified testing agency, on testing <br />agency's standard form, indicating and interpreting results of compatibility tests performed <br />before installation of product. Include written recommendations for primers and substrate <br />preparation needed for adhesion. <br /> <br />P. Field Test Reports: Prepare reports written by a qualified testing agency, on testing agency's <br />standard form, indicating and interpreting results of field tests performed either during <br />installation of product or after product is installed in its final location, for compliance with <br />requirements in the Contract Documents. <br /> <br />Q. Maintenance Data: Prepare written and graphic instructions and procedures for operation and <br />normal maintenance of products and equipment. Comply with requirements specified in <br />Division 1 Section "Operation and Maintenance Data." <br /> <br />R. Design Data: Prepare written and graphic information, including, but not limited to, <br />performance and design criteria, list of applicable codes and regulations, and calculations. <br />Include list of assumptions and other performance and design criteria and a summary of loads. <br />Include load diagrams if applicable. Provide name and version of software, if any, used for <br />calculations. Include page numbers. <br /> <br />S. Manufacturer's Instructions: Prepare written or published information that documents <br />manufacturer's recommendations, guidelines, and procedures for installing or operating a <br />product or equipment. Include name of product and name, address, and telephone number of <br />manufacturer. Include the following, as applicable: <br /> <br />1. Preparation of substrates. <br />2. Required substrate tolerances. <br />3. Sequence of installation or erection. <br />4. Required installation tolerances. <br />5. Required adjustments. <br />6. Recommendations for cleaning and protection. <br /> <br />T. Manufacturer's Field Reports: Prepare written information documenting factory-authorized <br />service representative's tests and inspections. Include the following, as applicable: <br /> <br />1. Name, address, and telephone number of factory-authorized service representative <br />making report. <br />2. Statement on condition of substrates and their acceptability for installation of product. <br />3. Statement that products at Project site comply with requirements. <br />4. Summary of installation procedures being followed, whether they comply with <br />requirements and, if not, what corrective action was taken. <br />5. Results of operational and other tests and a statement of whether observed performance <br />complies with requirements. <br />6. Statement whether conditions, products, and installation will affect warranty. <br />7. Other required items indicated in individual Specification Sections. <br /> <br />U. Insurance Certificates and Bonds: Prepare written information indicating current status of <br />insurance or bonding coverage. Include name of entity covered by insurance or bond, limits of <br />coverage, amounts of deductibles, if any, and term of the coverage. <br /> <br />SUBMITTAL PROCEDURES <br /> <br />01330 - 9 <br />