Laserfiche WebLink
<br />Copyright 2002 AIA <br /> <br />MASTERSPEC <br /> <br />11/02 <br /> <br />1.7 PRODUCT WARRANTIES <br /> <br />A. Warranties specified in other Sections shall be in addition to, and run concurrent with, other <br />warranties required by the Contract Documents. Manufacturer's disclaimers and limitations on <br />product warranties do not relieve Contractor of obligations under requirements of the Contract <br />Documents. <br /> <br />1. Manufacturer's Warranty: Preprinted written warranty published by individual <br />manufacturer for a particular product and specifically endorsed by manufacturer to <br />Owner. <br />2. Special Warranty: Written warranty required by or incorporated into the Contract <br />Documents, either to extend time limit provided by manufacturer's warranty or to provide <br />more rights for Owner. <br /> <br />B. Special Warranties: Prepare a written document that contains appropriate terms and <br />identification, ready for execution. Submit a draft for approval before fmal execution. <br /> <br />1. Manufacturer's Standard Form: Modified to include Project-specific information and <br />properly executed. <br />2. Specified Form: When specified forms are included with the Specifications, prepare a <br />written document using appropriate form properly executed. <br />3. Refer to Divisions 2 through 16 Sections for specific content requirements and particular <br />requirements for submitting special warranties. <br /> <br />C. Submittal Time: Comply with requirements in Division 1 Section "Closeout Procedures." <br /> <br />PART 2 - PRODUCTS <br /> <br />2.1 <br /> <br />PRODUCT SELECTION PROCEDURES <br /> <br />A. <br /> <br />General Product Requirements: Provide products that comply with the Contract Documents, <br />that are undamaged and, unless otherwise indicated, that are new at time of installation. <br /> <br />1. Provide products complete with accessories, trim, fInish, fasteners, and other items <br />needed for a complete installation and indicated use and effect. <br />2. Standard Products: If available, and unless custom products or nonstandard options are <br />specified, provide standard products of types that have been produced and used <br />successfully in similar situations on other projects. <br />3. Owner reserves the right to limit selection to products with warranties not in conflict with <br />requirements of the Contract Documents. <br />4. Where products are accompanied by the term "as selected," Architect will make <br />selection. <br />5. Where products are accompanied by the term "match sample," sample to be matched is <br />Architect's. <br />6. Descriptive, performance, and reference standard requirements in the Specifications <br />establish "salient characteristics" of products. <br />7. Or Equal: Where products are specified by name and accompanied by the term "or <br />equal" or "or approved equal" or "or approved," comply with provisions in Part 2 <br />"Comparable Products" Article to obtain approval for use of an unnamed product. <br /> <br />PRODUCT REQUIREMENTS <br /> <br />01600 - 5 <br />