Laserfiche WebLink
<br />Copyright 2003 AIA <br /> <br />MASTERSPEC Short Form <br /> <br />05/03 (R 05106) <br /> <br />E. Miscellaneous Sheet Metal Deck Accessories: Steel sheet, minimum yield strength of 33,000 <br />psi (230 MPa), not less than 0.0359-inch (0.91-mm) design uncoated thickness, of same <br />material and fmish as deck; of profile indicated or required for application. <br /> <br />F. Repair Paint: Manufacturer's standard rust-inhibitive primer of same color as primer. <br /> <br />PART 3 - EXECUTION <br /> <br />3.1 INSTALLATION <br /> <br />A. Install deck panels and accessories according to applicable specifications and commentary in <br />SDI Publication No. 30, manufacturer's written instructions, requirements in this Section, and as <br />indicated. <br /> <br />B. Place deck panels on supporting frame and adjust to fmal position with ends accurately aligned <br />and bearing on supporting frame before being permanently fastened. Do not stretch or contract <br />side-lap interlocks. <br /> <br />C. Place deck panels flat and square and fasten to supporting frame without warp or deflection. <br /> <br />D. Cut and neatly fit deck panels and accessories around openings and other work projecting <br />through or adjacent to deck. <br /> <br />E. Provide additional reinforcement and closure pieces at opening~ as required for strength, <br />continuity of deck, and support of other work. <br /> <br />F. Comply with A WS requirements and procedures for manual shielded metal arc welding, <br />appearance and quality of welds, and methods used for correcting welding work. <br /> <br />G. Mechanical fasteners may be used in lieu of welding to fasten deck. Locate mechanical <br />fasteners and install according to deck manufacturer's written instructions. <br /> <br />H. End Bearing: Install deck ends over supporting frame with a minimum end bearing of 1-1/2 <br />inches (38 mm). <br /> <br />1. Roof Sump Pans and Sump Plates: Install over openings provided in roof deck and [wetd] <br />[ mechanically fasten] flanges to top of deck. Space [welds] [mechanical fasteners] not more <br />than 12 inches (305 mm) apart with at least one [weld] [fastener] at each comer. <br /> <br />1. Install reinforcing channels or zees in ribs to span between supports and [weld] [ or] <br />[mechanically fasten]. <br /> <br />J. Miscellaneous Roof-Deck Accessories: Install ridge and valley plates, fmish strips, end <br />closures, and reinforcing channels according to deck manufacturer's written instructions. <br />[Weld] [or] [mechanically fasten] to substrate to provide a complete deck installation. <br /> <br />1. Weld cover plates at changes in direction of roof-deck panels, unless otherwise indicated. <br /> <br />K. Pour Stops and Girder Fillers: Weld steel sheet pour stops and girder fillers to supporting <br />structure according to SDI recommendations, unless otherwise indicated. <br /> <br />STEEL DECK <br /> <br />05310-5 <br />