Laserfiche WebLink
E. The Engineer's check shall be only for conformance with the design concept of <br />the project and compliance with the Specifications and Drawings. The <br />' responsibility of, or the necessity of, furnishing materials and workmanship <br />required by the Specifications and Drawings which may not be indicated on <br />the shop drawings is included under the work of this Section. <br />F. The responsibility for all dimensions to be confirmed and correlated at the job <br />site and for coordination of this work with the work of all other trades is also <br />' included under the work of this Section. <br />G. No material shall be ordered or shop work started until the Engineer's approval <br />of shop drawings has been given. <br />' 1.09 WARRANTY <br />A. Provide a warranty for all the electrical equipment in accordance with the <br />requirements of other Sections. Under no circumstances shall the warranty be <br />' for less than one year starting from substantial completion. <br />IPART 2 - PRODUCTS <br />2.01 GENERAL <br />A. The materials used in all systems shall be new, unused and as hereinafter <br />specified. All materials where not specified shall be of the very best of their <br />respective kinds. Samples of materials or Manufacturer's specifications shall <br />be submitted for approval as required by the Engineer. <br />B. Materials and equipment used shall be Underwriters Laboratories, Inc. listed <br />and conform with applicable standards of NEMA and ANSI. <br />C. Electrical equipment shall, at all times during construction, be adequately <br />protected against mechanical injury or damage by water. Electrical equipment <br />shall not be stored out -of- doors. Electrical equipment shall be stored in dry <br />permanent shelters. If any apparatus has been damaged, such damage shall <br />be repaired by the CONTRACTOR at his expense. If any apparatus has been <br />subject to possible injury by water, it shall be thoroughly dried out and put <br />through such special tests as directed by the Engineer, at the cost and <br />expense of the CONTRACTOR, or shall be replaced by the CONTRACTOR at <br />his own expense. <br />D. All electrical panels, enclosures, raceways, conduits, wireways, boxes, <br />' cabinets, etc., shall be fabricated of metal. Nonmetallic substitutes are not <br />acceptable. This does not apply to buried work. <br />2.02 RACEWAYS AND FITTINGS <br />09/03 16050 -5 03- 4138.A -R <br />